Hi. I am using leopardboard dm355
I tried to erase the flash using the command in LINUX.
$ mono sfh_DM35x.exe -nanderaseAnd appears on the screen:----------------------------------------------------- TI Serial Flasher Host Program for DM35x (C) 2008, Texas Instruments, Inc. Ver. 1.10-----------------------------------------------------Platform is Unix/Linux.Globally erasing NAND flash.Attempting to connect to device /dev/ttyS0...Press any key to end this program at any time.Waiting for the DM35x...BOOTME commmand received. Returning ACK and header...ACK command sent. Waiting for BEGIN command... Target: BEGINBEGIN commmand received. Sending CRC table...CRC table sent. Waiting for DONE...DONE received. Sending the UBL...$ mono sfh_DM35x.exe -nanderase----------------------------------------------------- TI Serial Flasher Host Program for DM35x (C) 2008, Texas Instruments, Inc. Ver. 1.10-----------------------------------------------------Platform is Unix/Linux.Globally erasing NAND flash.Attempting to connect to device /dev/ttyS0...Press any key to end this program at any time.Waiting for the DM35x...BOOTME commmand received. Returning ACK and header...ACK command sent. Waiting for BEGIN command... Target: BEGINBEGIN commmand received. Sending CRC table...CRC table sent. Waiting for DONE...DONE received. Sending the UBL...isn't missing somethink?? or its finish here??
set Both switches to OFF staet on the board then execute the following command to flash the u-boot for the leopardboard.
mono sfh_DM35x.exe -nanderase
mono sfh_DM35x.exe -nandflash ubl_DM35x_nand.bin u-boot-1.2.0-dm355_leopard.bin
yes, I did it.
but, when I write "mono sfh_DM35x.exe -nanderase"
appear:
-----------------------------------------------------
TI Serial Flasher Host Program for DM35x
(C) 2008, Texas Instruments, Inc.
Ver. 1.10
Platform is Unix/Linux.
Globally erasing NAND flash.
Attempting to connect to device /dev/ttyS0...
Press any key to end this program at any time.
Waiting for the DM35x...
BOOTME commmand received. Returning ACK and header...
ACK command sent. Waiting for BEGIN command...
Target: BEGIN
BEGIN commmand received. Sending CRC table...
CRC table sent. Waiting for DONE...
DONE received. Sending the UBL...
and stop..... need I abort the program to write the second command (mono sfh_DM35x.exe -nandflash ubl_DM35x_nand.bin u-boot-1.2.0-dm355_leopard.bin)???
Someone can help?
Please see:
designsomething.org/.../97.aspx