Hello,
I have been attempting to configure RR so that it will connect to my network. However, when I do perform an ifconfig on the Leopardboard 365, eth0 does not show up.
I have downloaded the SD image the RR has posted online and have been able to successfully load it onto the board and ping various network nodes. This leads me to believe that it is the board's image that is the problem rather than the host machine. Thus far I have been unsuccessful in configuring the image properly in order to replicate the RR image.
Does anybody have tips on what configuration settings I need to look at in particular? Also, are there any references out there showing what configurations settings were used in the RR image?
Regards,
cg
www.finitemagic.com