This may already be a known problem but the search engine of this page does not work...
I have just received my Leopoard 365 board. I also bought a 1.3 MPix camera but… it doesn't fit.
There is a small 2-pin white connector for the composite cable which prevents the camera board to be
fit to the Leopard 365 board.
Here are some pictures:
Yes, it is a little tight there, but you can bend just a little bit to get the camera board to be plugged into Leoaprdboard.
Thanks for your reply.
Yes, that's what I did. I just wanted to report it in case a new version is planned.
By the way, if I may suggest something for a new version:
An alignment of all the output jacks would make it easier to design a case.
The ethernet jack is about 5.5 mm out of the board bounds, and the other jacks
between 1 and 2 mm, but not aligned either.
In the meantime, I made this :
which is a plain board holder, just to keep the camera horizontal. And it also avoids
short circuits that might happen with the mess on my desk.
Look GREAT, Pascal, that will protect board very well, especially shortage on bottom.
By the way, we tested Video input board, it works now, we are building some boards, we should be able to get it done in two weeks, sorry for the DELAY. :-(
When Video input board will be available?
I know I keep saying it is coming, sorry for the delay because of part collection, the good news is both Component input board and Composite input board are in assembly line already, they will be ready to ship next week for sure. You can start to order from online shopping cart now: