I was just trying to get the wifi connectivity up and working on my Leopard DM365 board. I saw in the below link that one of the Belkin wifi dongle is supported and tested (please see the link below)
I tried to follow the steps but i see that the dongle is not been detected.
Any input would be really helpful.
Did you configure your hw to be in USB host mode of operation?
I enabled the USB host mode as explained in the link, but still it is not working. below is the message gets printed when i plug in the USB Wifi dongle:
usb 1-1: USB disconnect, address 3
usb 1-1: new high speed USB device using musb_hdrc and address 4
usb 1-1: configuration #1 chosen from 1 choice
if i do iwconfig i get:
lo no wirnet eth0: DaVinci EMAC: ioctl not supported
eth0 no wireless extensions.
can you please point out what is the mistake i may be doing. it would be really helpful.
Sounds like the kernel drivers you need are being built. Please post your SDK configuration file
so I can review your kernel configuration.