Hey,
I have made some successful tests to capture some images with the camera (5MP) when I plug in the camera module board (LI-MOD02).
But then, I'd like to place the camera further from the board (approx. 1 meter) using 2 Samtec cables (that fit well with the existing connectors) and it does not work well. I'm getting a noisy image where a few features can be recognized and the colors are completely messed up.
I measured the resistor through the cable using my multimeter and I'm getting low values (around 1.2ohms).
Any idea on how to improve the connexion?
Thanks,
Mike
1meter is too long for high frequency signal, 50mm~100mm should be the Max .length, or it has to be differential signal.
- Bill
How do I build a differential signal with the Leopard Board?
Is there any chip that handles these signals?
FYI I am now using two flat ribbon cable (the FFSD-20-D-12.00-01-N from Samtec) connected one after the other and I'm getting an image out of it (although it's a bit purple in places that a bright, such as lamps). The length of the extension is 0.6m