Hi Everybody
I recently got a Leo368 with RR 2011Q2 SDK, I can easily manage to load OS with SD Card and deploy images with serial (RS232) interface (it takes more than an hour!) but I can't manage to set up properly TFTP.
I think that there is a problem of configuration of tftp server but I can't find what it is!
Here the installer configuration:
Firmware deployment mode (Attached board on communication port) --->(eth0) Interface on your host machine connected to your target hardware *** Installer to U-boot communication options ***Communication method with the target board (Serial port)->(/dev/ttyUSB0) Serial port for target communication *** Transfer options for installation *** Protocol for transfering images to the target (TFTP) --->(/srv/tftp) TFTP server path *** Network options for installation *** U-boot IP address (Static IP address) --->(192.168.1.2) Static IP(255.255.255.0) Static mask
is it right?
What else should I have to set up for TFTP?, I have already done what is written on https://www.ridgerun.com/developer/wiki/index.php/Setting_Up_A_Tftp_Service and many other posts
I think I can't assign ip addresses for LeopardBoard and TFTP server on my host, any suggestions?
Many thanks in advance
Mauro
Hi,
You get this error:
"installer/u-boot-installer/Makefile:25: *** Unable to identify the IP address of your machine on interface "eth0", please check your configuration variable INSTALLER_HOST_NET_INTERFACE. Stop."
Because the eth0 can't be found. The command:
ifconfig
Will show the interfaces from your computer, please check if eth0 is available.
Carlos AgueroEmbedded Software EngineerRidgeRun
Further information:
When I use that configuration and I try a "make install" o "make config" and so on, I got always this error:
installer/u-boot-installer/Makefile:25: *** Unable to identify the IP address of your machine on interface "eth0", please check your configuration variable INSTALLER_HOST_NET_INTERFACE. Stop.
So I have to manually edit bspconfig and restart with make config, why this error??
pa@pa-desktop:~/LeopardBoardDM365sdkEVAL2011Q2$ `make env`
eth0: error fetching interface information: Device not found
pa@pa-desktop:~/LeopardBoardDM365sdkEVAL2011Q2$ ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:9786 errors:0 dropped:0 overruns:0 frame:0
TX packets:9786 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1577345 (1.5 MB) TX bytes:1577345 (1.5 MB)
wlan0 Link encap:Ethernet HWaddr 00:19:5b:7f:d6:94
inet addr:192.168.2.26 Bcast:192.168.255.255 Mask:255.255.0.0
inet6 addr: fe80::219:5bff:fe7f:d694/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:129392 errors:0 dropped:0 overruns:0 frame:0
TX packets:111679 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:172829070 (172.8 MB) TX bytes:12937468 (12.9 MB)
I have a wireless internet connection. What should I do??????
Hi Guys ... Sorry I could say earlier