Hello, When trying to program the Leopard Board 365 I've just received (v1.4) I am getting an error (using the SD card Flash programmer): SD card boot and flashing tool for DM355 and DM365 by Constantine Shulyupin http://www.LinuxDriver.co.il/ Online manual: http://wiki.davincidsp.com/index...

I have been attempting to flash my Leo 365 with the SD Flash Utility for DM3xx and have been receiving Write Verify Failed/Data Verification Failed. Has this issue occurred previously? At the moment, I only have one 2GB SD card, all of my others are SDHC and therefore not compatible. At the moment...

Hello everybody, I am trying to design my own PCB around the DM365 chip, mostly a copy (exact same components) of the Leopard Board. I am wondering if there is anything particular I should be aware of when programming the chip for the first time. I would like to use the USB 720p HD video streaming...

We looked at SD cards and decided to get 4GB Class 6 ones to start with. But that's all I can say at this point, I haven't been using them for file storage just yet (we use only NFS right now). But I believe they are suitable for the DM365 Leopardboard (with recent 2.6.32 kernel) from what I...

Hello, Using RR SDK ( the SVN version ) I was trying to compile some applications and install a JFFS2 file system image as I've seen to be recommended over CRAMFS in some other post. Unfortunately it seem to not work, all the other components are installed OK but after the new FS image is transferred...

Hi I have a Leopardboard 355.= and will soon get a Leo365. Can any of these two boards boot from a SD card? Is it possible to load the bootloader and kernel images directly from the SD card?? Any advice will be greatly appreciated.

Hi there I have downloaded the bootable sd card images for the RidgeRun site. Can anyone please tell me how I can make my own bootable sd card images? Is there a guide?

Hi everyone I want to do a project on a Leopardboard this year. I want to detect motion, take a snap shot after motion is detected and then start recording video and audio. The problem is that I have no experience with either OMAP or DAVINCI software; as a matter of fact I have never programmed...

Hi, I am a newbie to Leopardboard and I am using the DM365. As mentioned in the Ridge runner SDK I have attempted to load the image through SD Card. But when I configure the Leopardboard to boot from SD card and switch on - nothing is displayed on the serial console (Connected via minicom). What could...